CAMBOX V4 PRO
UPDATE
Please download the latest version of your Cambox embedded firmware.
V.1.2.0
Update of February 1st 2021
How to process to the update
1 - Make sure your Cambox is off
2 - Take the SD card out of your camera and insert it in your computer.
3 - Download the latest update available
4 - Insert the downloaded file (without open it) at the root of your camera SD card.
5 - Insert the SD card back into your Cambox.
6 - Turn on your Cambox (Power led flashes during the update)
7 - Wait until the end of the update and wait for the unit to turn off automatically (approximately 5 minutes)
8 - Restart your Cambox
The update has been completed.
PREVIOUS UPDATES
Version 1.2.0
Camera powering off protocol fix
Camera starting protocol fix after connecting the camera to macOS devices
RTSP video stream management optimization
Change of the blue Power LED when RTSP video stream is activated
Addition of the feature allowing to format the memory card from the mobile app
Addition of the feature allowing to force the camera extinction from the mobile app
Addition of the SD card format from macOS
Version 1.1.9
Integration of the RTSP stream to enable the video preview mode feature on the mobile app
Switch from video preview mode to recording mode without turning off the Cambox
Addition of the USB MSC (Mass Storage) protocol allowing to recognize the camera on all types of devices
Addition of the battery voltage reading via CGI request
Version 1.1.8
Change of the camera default settings
Modification of the white balance default value : Previous value = 12 (warm color) // New value = 0 (Automatic)
Optimization of the default picture sharpness : Previous value = 7 // New value = 12
Reduction of image noise (Edge strenght) : Previous value = 7 // New value = 12
Version 1.1.7
Optimization of the energy control feature : smoothes the values to avoid detection peaks
Addition of the blinking white Power LED during the OTA update
Version 1.1.6
Update of the camera date and time
Process for remote Cambox update (OTA file : Over The Air)
Automatic shutdown of the camera once update has been completed
Verification of the presence of the config.ini file and automatic creation of this file if it is missing from the SD card
Verification of the SD card presence and compatibility. In case of default, the power LED will blink purple.
Addition of the battery energy control. Low battery = Battery LED blinking red // Critical battery = Batttery LED solif red & automatic save of the last video file
Version 1.1.5
Optimization of the required time to use the Power button (pause mode / launch video record / powering off)
Activation of the white LED to signal the ignition phase of the camera
Change of the LED color during recording phase : Green LED = Recording // Red LED = camera is paused
LED brightness management via the config.ini file
Audio correction
SD card presence verification